Maintenance & Technical > KX500 Original

fitting wheels from a kxf.

<< < (4/4)

alward25:
People have swapped bearings to make the kxf hubs work.  But, I think the spacer adapters from Warp 9 would be the easiest solution.  They also said they use a custom cut rotor for the wheel like the one I have.  It is $65 plus shipping.  So if you are going through the effort of swapping wheels Warp 9 is not a bad way to go since you get a complete wheel all ready to go with rotor and sprocket for about $360 a wheel.  But if you have a kxf wheel there are the bits to swap out too.
Good Luck
Alex

Goat:
I've been looking into Warp9 wheels in my bored time and they seemed to be the only ones still willing to accommodate the older bikes like the K5. I've contacted a couple other companies I've found and started asking questions but when they found out it was going on a K5 they said they couldn't help and hung up on me. So I've just been trying to save my pennies and get the Warp9's with green hubs and black rims :D

alward25:
I do like the green hubs and black wheels.
BRAAAPPP!!!!!

Navigation

[0] Message Index

[*] Previous page