Maintenance & Technical > KX100 / KX85 / KX80 / KX65 / KX60
KX60 HELP! In need of rebuild!
chris-mets:
Ok so I rub oil with my fingers everywhere when I finally finish the engine. Then I fill it up with the oil.
1989kawasaki:
--- Quote from: chris-mets on April 13, 2011, 01:53:30 PM ---Ok so I rub oil with my fingers everywhere when I finally finish the engine. Then I fill it up with the oil.
--- End quote ---
only coat the cyl, piston , rod bearings, crank bearings. then put in the tranny oil
chris-mets:
Ok thanks. Will do but for now im working on the stripped screws holding the engine together.
Motorrad:
--- Quote from: chris-mets on April 13, 2011, 01:35:27 PM ---yep. I pushed the rings in with my fingers and it went in. It's just that when its in the cylinder I can't move it anymore. It's really tight in there.
--- End quote ---
Sure the rings are lined up with the locating pins? and you put it all together straight...
Sounds like ring hooking a port to me...
chris-mets:
Nevermind I solved that problem. Thanks Anyway!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version