Maintenance & Technical > KX100 / KX85 / KX80 / KX65 / KX60
KX60 HELP! In need of rebuild!
Motorrad:
--- Quote from: chris-mets on April 13, 2011, 11:35:28 PM ---Nevermind I solved that problem. Thanks Anyway!
--- End quote ---
What was the problem?
chris-mets:
Well It didn't slide up and down without oil and then I couldnt get it in the cylinder because I didn't squeeze the rings together.
DoldGuy:
Make sure the letter on the ring is facing up too.
DoldGuy
chris-mets:
Yes, I checked last night and they are both up...both rings just said N100 on them and I put both words up
chris-mets:
Ok guys, this is where I am at right now. I got my local shop to take the phillips engine bolts out then the next day I got help from them again with taking out the flywheel. The guy was nice and did it for free even though he doesn't even work on dirt bikes. I don't want to bother him again. I have the flywheel and stator off of the bike. I am trying to split the engine so I have to take the clutch and the primary gear and the kick start idler off, correct? The bolts are all too tight I can't get them. The thing is I would need a case splitter and a crank puller installer after I get those bolts off. I would also need to buy the crankshaft that comes with seals, bearings, and gaskets. Does anyone have the tools I could borrow? I am already far into this project. After I buy the crankshaft kit I am 950 into this bike. I would be very greatful if someone would let me borrow their tools for splitting the cases and putting the crank off and on. Thank you.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version