General > Riding Tips & Tricks

anyone got a method?????

<< < (2/2)

kaw rider:
yes the welding deal works out great. I used that deal one then once.

Johnniespeed:
A long punch from the other side should be the easiest. Another try could be with a slide hammer that has a hook end.

gray hair:
 I have run into this many times when working on my vehicles, but not on my bikes yet. When I do encounter it, I stuff a rag into the hole to prevent debris from entering it while I'm working and I take my dremel tool to it with a cut-off wheel. I don't cut all the way through, but very close. Two or three cuts and some tapping with a chisel and they normally come out. Just be cautious so you don?t damage the housing the race is in.
 Good luck.

Navigation

[0] Message Index

[*] Previous page