General > Riding Tips & Tricks

anyone got a method?????

(1/2) > >>

klemet:
the outer part of the bearing(raceway) didnt come out of the wheel  :? any method of geting it out???

BDI:
I have welded washers to stuff like that before to pull it.

jfabmotorsports.com:
Also just placing 2 or 3 small welds on the bearing race itself will shrink if enough that it will fall out. TIG would be the preferred method. 

JFAB

Friar-Tuck:
 K,
 I have had to cut through the Bushing/bearings and such to the point where you can either relieve enough pressure to tap it out or end up making two cuts 180 deg apart. (cut in half) and  punch or chisel the stuff apart. 
   Dremmel, Hacksaw Blade Etc. 
I know it may be slow going working around the aluminum... :|
  Tuck\o/ 

KXcam22:
If you have access to an arc welder the easiest method is to run a bead of weld on the inside of the race.  When it cools it shrinks the race a few thou and the race drops out. Also sometimes you can use the edge of a bolt head and fab up jury rigged puller. Can you not tap it out from the other side of the wheel with a long punch?? Cam.

Navigation

[0] Message Index

[#] Next page