Maintenance & Technical > KX250 / KX125

brand new clutch still haveing problems

<< < (2/2)

Hillclimb#42:
Disconnect cable from engine. Does it roll while in gear? That would tell you if its inside or out. Possibly need to add slack with new cable in the cable adjustment.

Friar-Tuck:
 Like Hill #42 said.
  With the clutch cable disconnected you should still be able to rock the bike back and forth and get her to shift through the gears.  Don't hammer on the shifter.    A little tug in either direction will get it to shift as the gears move.

 There should be at least about the thickness of a nickle slack between the lever and the perch when you start to feel the slack taken out of the cable and disengage the clutch.
. 
     If that doesn't help...start working backwards...  through clutch, and unfortunately back through to the tranny.
           Tuck\o/

havoc raceing:
i disconected the cable from the clutch and put it in gear and it was working like it should when the clutch is disengaged then it also worked when i engaged the clutch so its just the cable then

havoc raceing:
thanks for the help guys works just fine now

Friar-Tuck:
      8-)     :-D

Navigation

[0] Message Index

[*] Previous page