Maintenance & Technical > KX250 / KX125
brand new clutch still haveing problems
havoc raceing:
so i bought new plates disks and springs and i put it in the bike and when i start the bike i put it in gear and the back wheel wont move at all even when i rev it up i could use some help :?
Hillclimb#42:
Do you have a bit of slack in cable? Is the clutch arm moving, when you pull the lever? Its permanently in neutral? Give some more detail.
kaw rider:
Did you put it into gear :-D
havoc raceing:
i have tryed it in all five gears everything mves like it should and i just replaced the whole transmistion ans it goes into gear fine and i have a brand new cable too and it is the right size
Dutch-K5 Fan:
If you motor is not running and you put it in gear.
Can you feel it locking into his gears????
Could it be that the gear on the crank came loose, and there for it doesn't
turn the rest of the engine??
Rear Chain???? Sound stupid mabey.
Dutch
Navigation
[0] Message Index
[#] Next page
Go to full version