The Haas KX500 build. Dyno Doug Haas

Commercially available service offered by members of KXRiders. > OEM-CYCLE

<< < (2/4) > >>

sandblaster:
I took the 2019-21 KX450F shock and Cerakoted it in Copper...
I went ahead and did the Unitrak linkage as well...

sandblaster:
had Doug weld on this rear brake master cylinder relocation tab for using a 19-21 KX450F master cylinder.

sandblaster:
What is this?
A custom Dyno Doug skid plate.
It's a one off.
Nothing else will fit this set up..

sandblaster:
Before I sent this frame off to Doug, I mocked everything up to be sure I would have the proper clearances.
So far, so good 8-)

sandblaster:
I bought these engine mounts and the rear muffler bracket from Jonathon Bell in the UK..

Navigation