Commercially available service offered by members of KXRiders. > OEM-CYCLE

CR500 Kart engine rebuild

<< < (4/7) > >>

sandblaster:
The results?

3 laps in...





The reason?

Plugged pilot, and floats set too low.

Lesson learned... Next race build, we will have the carb, check the jetting, and break the engine in.

sandblaster:
Yesterday we received a 91mm CR500 Wiseco piston.
I took the cylinder and piston to the machinist and told him the specs I wanted it bored to. I should have it early next week.
We will be getting the Kart this time so we can tune it and break it in over a few days.
I can't wait....

sandblaster:
Ready for it's first heat cycle...



https://youtu.be/NyoDQR4CDTY

sandblaster:
I think Jason want's one...
This pic was taken after the fourth heat cycle yesterday evening.
I'm sure my neighbors are just as happy about it as I am  :-D



I want one as well... But I want mine to be green  8-)

Foxx4Beaver:
I'll take one too...but make mine outa Mahogany....seeing's how I'll probably need to be buried in it. :mrgreen:

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version