Commercially available service offered by members of KXRiders. > OEM-CYCLE
CR500 Kart engine rebuild
sandblaster:
Race results.
1st heat placed 1st.
Second heat placed 4th.
Main was in second but spun out. Had to start over from the rear of the pack, ended up placing 3rd but was DQ'd due to a early restart that everyone says was bunk.
Oh well, that's racing.
Overall I'm not dissatisfied with the results especially considering that we have a lingering lean issue.
We think we know the cause but will get it resolved next week.
We do have two weeks before the next race so I'm certain we can get this figured out.
Special thanks goes to Adam Millar for his technical support.
Without Adam's help I'm sure we would have finished at the back of the pack....
reklessj:
--- Quote from: sandblaster on May 21, 2016, 03:17:45 AM ---Race results.
1st heat placed 1st.
Second heat placed 4th.
Main was in second but spun out. Had to start over from the rear of the pack, ended up placing 3rd but was DQ'd due to a early restart that everyone says was bunk.
Oh well, that's racing.
Overall I'm not dissatisfied with the results especially considering that we have a lingering lean issue.
We think we know the cause but will get it resolved next week.
We do have two weeks before the next race so I'm certain we can get this figured out.
Special thanks goes to Adam Millar for his technical support.
Without Adam's help I'm sure we would have finished at the back of the pack....
--- End quote ---
Any vids
sandblaster:
Unfortunately we were too busy trying to figure out why we were having a tuning issue..
We think we have it sorted out but will have to verify next week.
reklessj:
Right on, want to see that thing rip
sandblaster:
Then I'll probably need to throw a KX500 engine in it :evil:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version