Maintenance & Technical > KX500 Steel Frame Conversion (SFC)

steel frame head mounts

<< < (3/6) > >>

motopunk:
i found the time yesterday to make pics of my handmade front headstay on my´86 kx500 motor in the ´93 kx250 frame ..







hope it helps a little bit  :-)

yeomans:
That helps out quite a bit.
I had started making a mount very similar to that, but I like your idea better,
I was having a hard time visualizing how to match the piece of steel on the head to the triangle mounts on the frame without looking like crap.

Thanks a bunch

yeomans:

--- Quote from: kranker1450 on January 29, 2014, 01:02:23 PM ---2000 Kx250

--- End quote ---

Is the mount going to be welded onto the frame or bolted?
I'd love to weld it but not any decent flat steel to weld to because of where the 250 motor mounts land.

motopunk:

--- Quote from: yeomans on January 30, 2014, 06:33:52 AM ---That helps out quite a bit.
I had started making a mount very similar to that, but I like your idea better,
I was having a hard time visualizing how to match the piece of steel on the head to the triangle mounts on the frame without looking like crap.

Thanks a bunch

--- End quote ---

oh i had a long head scratching session beside the bike, till i came to that point . little bit inspired from the j-fab mount kit, but this is only available for the newer engine  and not useable for the 86-88 cylinderhead ..

yeomans:
Yeah, its one of the things I've been putting off the longest.
It's the last thing I have to do before the powder coat.

Navigation

[0] Message Index

[#] Next page

[*] Previous page