Maintenance & Technical > KX500 Original

Drilled flywheel

(1/4) > >>

martinfan30:
Searched, but no exact answers.

Has anyone drilled the flywheel to lighten it a little?

kaw rider:
don't drill the flywheel, you what to machine the OD.

martinfan30:

--- Quote from: kaw rider on October 03, 2010, 06:11:16 AM ---don't drill the flywheel, you what to machine the OD.

--- End quote ---

Ok, any recomendations on where to get it done? How much to take off?

I ride desert, and alot of single track, I just want a bit more snap...

dave916:
the ideal setup would be for u to the 86-89 flywheel stator , its got a far smaller and lighter flywheel ,   
if i was going to skim the flywheel i would rather get someone who could balance it aswell

martinfan30:

--- Quote from: dave916 on October 03, 2010, 06:56:47 AM ---the ideal setup would be for u to the 86-89 flywheel stator , its got a far smaller and lighter flywheel ,   
if i was going to skim the flywheel i would rather get someone who could balance it aswell

--- End quote ---

does the wheel and stator bolt up with no mods?

Navigation

[0] Message Index

[#] Next page