Maintenance & Technical > KX500 Original

Quick help with V-Force 3

<< < (5/5)

BDI:

--- Quote from: stewart on March 30, 2010, 01:49:57 AM ---here is a picture of the rad valve with the reed block machined off the area is very small

--- End quote ---
Thats what I want a rad valve for right there. Stewart does it look like theres enough metal to fit it to the V-force.

kaw rider:
Stewart
You would be surpised on how small you could go with the tunnel before it causes performance problems. It all depends on the use of bike and motor.

kawi4ever:
I checked the rate of water flow between my v-force 3 and rad valve, and i had some interesting results..hopefully stewart can chime in.. I used a exact measure of water (about 12ounces) in each valve and the V-force was 24.89 sec to drain but the Rad valve was 46.7 sec and did not fully drain.. This has me stumped.. hopefully stewart or anybody else that tests there reed tension like this could help. Thanks  :-D

Navigation

[0] Message Index

[*] Previous page