Maintenance & Technical > KX500 Original

Quick help with V-Force 3

(1/5) > >>

kawi4ever:
Hi I just got my cylinder back from plating and my new V-Force 3 in, and when I install the V-force it is very snug in the cylinder, like the reed stops and too wide for the opening in the cylinder and when installed they actually are squeezed a little. Is this NORMAL with V-3 ? Please anybody that has installed these please let me know. Thanks ERIC  :?

stewart:
they do fit snug ..if there to tight sanding roll on a die grinder till some slight clearnce should do fine but rinse very good to remove grit

kawi4ever:
Thank you, i am going sand a little to give some space. Thank You  :-D

kawi4ever:
Just got done sanding and grinding, what a joke just to get them snug and not super tight.. I hope this was worth it over the Rad Valve I already had in the engine before rebuild...

stewart:
it s worth it

Navigation

[0] Message Index

[#] Next page