Maintenance & Technical > KX500 Original

help

(1/3) > >>

kiwimonster:
hey guys whats the standard k5 carby.   i changed my throttle cable orderd  standard kawasaki 2000 model k5 one and its too short pissed about for 2 hrs thinking im having a blond moment. so i rang the kawa dealer .  he asuures its correct so then i managed to read the numbers of the old cable and low and behold its off a 1998 kx 250.   so order one of them today.   

now the numbers on the carby   . kehein pwk   g250 ange    40 mill small diam  59 mill  airboot side.   is this a standard carby  helllllllllllllllllllllllppppppppppppppppp. cheers. :mrgreen:

fluffy:
my book says 88 500 pwk39 89 pwk39. 1990-99 pwk39 2000 on pwk39.1983-87 used mikuni.

Friar-Tuck:
G'Day Kiwi,
 I also have a 2000 kx5 I believe to be stock.  My Keihin has G260  ANF3 etched in the side of the carb body on the
clutch side just above the bowl.  Like fluffy said it should be a 39.5   The number/lettering  on the side of the carb looks to be etched in with a small die grinder.  I'll snoop around and see if I can find out what the #'s indicate.
  Tuck\o/

kiwimonster:
cheers mate i only measured the size with a crap tapemeasure so it may well be 39.5 mine also looks like etched numbers on the carb,   dont know why it has a 250 cable. does your cable go straight into the top of the carb , mine has a steel pipe with a bend in that the cable pushes into that and is held by a little clip.  cheers.

Friar-Tuck:
 Kiwi,
 In regards to the "pipe" in the top of your carb, No my bike does not have it.
If you click on the Sudco link below and go to Carb Accsessories  pg. 90  on the bottom right of the page you can find the
item your speaking of.   
    I have worked on a few other bike that had them.   Pretty good idea I think to "get the cable around" the angle of the carb top and pointed toward the throttle with the least possibility of kinking, if you only have a few inches to make the transition.  ( just like some of the clutch cables at the case mount)
     There seems to be enough room between the carb top and the fuel tank on my bike that the angle isn't that bad,
and if you dont need to 90 right out the top of your carb you could probably "Lessen" the degree of angle to reduce the resistance of the cable in the pipe.   Small tubing bender or bench vice should work, just beware of the possibility of a kink  :| , and not a bend..
 
http://www.sudco.com/onlinecat33.html

 I haven't had any luck decifering the #'s and letters on the carb body, nothing at Keihin.com or sudco.com.
  I did look up the 2000 kx250 and it does infact show the "pipe" on the top of the carb. Hmmm...
The 250 carb is a 38s (I'm thinking -short-). It should "sharpen up" the throttle reponse at the cost of some top end if you have the 38.   

 Does the top of your carb screw on (round)  or does it bolt on (shaped like the throttle slide, and flat) ?

    Only reason I ask is the 38s has a top that is not the more traditional round screw on type, it's flat with o-ring gasket.
Tuck\o/

Navigation

[0] Message Index

[#] Next page