Maintenance & Technical > KX500 Original

Handlebars for tall riders

<< < (3/3)

Craptabulous:
I am at 4000 feet ,40:1 fmf fatty and silencer on 94 octane . 3rd clip 168 main 58 pilot im thinking about switching to a 165 and a 55 on the third clip . Its about 25 celsius .  I usually only go up in elevation . Very rarely below 3000 feet . I have a very small over bore

sandblaster:
55 168 is what I run at 0-1500 ft.
I ran the same jetting at 4000-4500 ft and it might have been ok if I dropped the needle 1 clip deeper.
Whatever you do.... throttle chops are a must.

Craptabulous:
Oops some how that ended up in the wrong thread. Does that sound lean to you ?

Just to add to this thread since i feel bad about my miss post . I recently installed a solid mount tag upper clamp with a set of fat bars and pillow tops , i was very impressed with the difference in vibration level , i thought it would go the other way . 

Sideplater:
I'm using a set of bar risers on my '04 along with my XR650 bend 'Answer' bars.

Awesome.

I'm 5'10, always found the standard bars too low

Navigation

[0] Message Index

[*] Previous page

Go to full version