Author Topic: Two fork assembly ?s  (Read 39 times)

0 Members and 1 Guest are viewing this topic.

Online 1980mcneil

  • Full Member
  • ***
  • Posts: 88
Two fork assembly ?s
« on: June 30, 2020, 03:55:26 PM »
Going to try and finish rebuilding my forks tomorrow. I just have two questions.

1. ďRod, fork, innerď part #46102-1403.  Thereís a hollow rod that goes inside the rod assembly and then on top of that on the very top of the fork just under the cap thereís a little 2 1/2 inch piece of rod with what looks like a ď flat head screwdriver slotď. I need to know the orientation of this part. Slot pointing up or down? I donít remember and I canít find a detailed enough drawing.

2. Is there a washer on the bottom of the fork spring? I donít think Iíve seen one in any parts breakdown. I know there is a washer on the top that fits a little bit inside the spring but on the bottom I have nothing.  Mine was just resting against a lower tube assembly part. (The one you need a special tool to unscrew)

Thanks guys
« Last Edit: June 30, 2020, 03:58:52 PM by 1980mcneil »
2004 kx500
Accu-products decompression Valve
Powerdynamo heavy flywheel ignition
Pro-Circuit Platinum II / FMF PowerCore 2
Moose racing Reed spacer
Baja design duel sport kit
Plated.