Maintenance & Technical > KX500 Original
Rekluse Radius X auto clutch now available!!!
510rider:
Exact same way. Adjusted the cable to 0 free play. Then 3 more turns out for baseline. Ended up going out 2 more full turns on cable adjuster . That’s it!
WRXBRUMBY:
510
1.Have you noticed any excess slipping in low rev high load conditions or does it lock up solid when you twist the throttle hard?
2.How do you perceive the wear in period to be, was there one?
510rider:
No wear in at all. No slippage at all. But mine is set up correctly. As with anything, correct set up is most important! It’s easy to do. Just take the time to do it right and you will be very happy!!!!!
WRXBRUMBY:
510 are you running a reed spacer?
And this maybe a dumb question but are you able to elaborate on what is a correct setup? This might save me pulling my hair out reinventing the wheel.
Cheers
510rider:
I took mine out of the box and put it in! Removed all free play from cable and then went 3 more turns on cable as instructions said. Ended up going 2 more turns on the cable to get it to not creep. It’s that easy.
You can put different springs in it but I just followed what the manufacturer recommended.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version