Maintenance & Technical > KX500 Original

Can this case be fixed??

<< < (3/3)

sandblaster:
Your first video question is here:

http://www.oem-cycle.com/forum/viewtopic.php?f=40&t=67

Another way to fix your engine case is you can have it industrial plated as shown in this build

http://www.oem-cycle.com/forum/viewtopic.php?f=41&t=1027

Lon:
Thanks again guys and good to know this side case can be repaired :) ...

kxpegger:
Should have been more specific as green is what we use at work on our pumps and other mechanicals exposed to oil and grease.

http://www.henkelna.com/product-search-1554.htm?nodeid=8797928521729

dave916:

--- Quote from: Motorrad on October 25, 2015, 04:04:39 PM ---Just make sure you dimple (peen) that bearing surface good...   And press the bearing in with both case and bearing same temp nice and square. (Use a good press).    The loctite doesn't like the heat freeze method.......  Don't forget the crank seal ;0)

--- End quote ---

What do u use for dimple {peen} bearing surface?

Navigation

[0] Message Index

[*] Previous page