Maintenance & Technical > KX500 Original

KIPS

<< < (2/4) > >>

dave916:
looks like the valves are not closing, Try removing the allen stop stud {kipps bolt mod} to see if they close futher
they look fine on the opened position
maybe somone hase already modded the kipps bolt

Mike Grant:
https://www.youtube.com/watch?v=HkPU6V-cIxE .......found this when I got lost on youtube last night.....is this the same as the 500's

vagassasson:
If the bolt were longer then the port would be closed all the way

dave916:

--- Quote from: vagassasson on September 20, 2014, 01:02:44 PM ---If the bolt were longer then the port would be closed all the way

--- End quote ---
then u need the kipps bolt mod ,a longer bolt {about 3mm] 

vagassasson:
I'm not really worried about the kips mod at the moment I'm just trying to figure out if my kips is setup correctly

Navigation

[0] Message Index

[#] Next page

[*] Previous page