Maintenance & Technical > KX500 Original

Bearing Removal

(1/3) > >>

cmotodad:
I need to replace the bearing on the clutch cover for the PV governor. Tried heat and it did not drop out. Any ideas? Thanks, Bob

Goat:
Blind hole bearing puller. I have rented them from the local auto parts store. Don't heat the cover too much or you could warp it and cause an oil leak when you put it back together.

cmotodad:
I went with light heat and a small tap with a plastic tipped hammer. No movement. Will look a for a blind bearing remover. Thanks, Bob

sandblaster:
Like this

http://www.oem-cycle.com/forum/viewtopic.php?f=39&t=64&p=88&hilit=BLIND+BEARING#p88

Foxx4Beaver:

--- Quote from: sandblaster on February 07, 2014, 05:23:40 PM ---Like this

http://www.oem-cycle.com/forum/viewtopic.php?f=39&t=64&p=88&hilit=BLIND+BEARING#p88

--- End quote ---

nicely written as usual!....but is that price you have listed for the puller still good?...I'm only asking because Motion Pro's site is saying $271.99 :?

Navigation

[0] Message Index

[#] Next page