Maintenance & Technical > KX500 Original
Bearing Removal
Pmcg:
I got a crappy one off of eBay for 35.00. It works great the only bearing I couldn't get was the clutch actuator because it was too deep down in the case.
alward25:
Harbor Freight has one just like it, probably made in the same place for way cheaper. Like $50 or less and we know who has one the get the lower clutch bearing :-D right PMCG :wink:
Foxx4Beaver:
--- Quote from: Pmcg on February 08, 2014, 03:27:06 AM ---I got a crappy one off of eBay for 35.00. It works great the only bearing I couldn't get was the clutch actuator because it was too deep down in the case.
--- End quote ---
I think Alward25 has the set-up for the acuator :wink:
--- Quote from: alward25 on February 08, 2014, 03:27:49 AM ---Harbor Freight has one just like it, probably made in the same place for way cheaper. Like $50
--- End quote ---
cool, thanks Alex...I'll check them out.
Foxx4Beaver:
Cool...thanks guys, I'll take a look on e-bay...and yes, Alex, you're right about Harbor...they have one that's a couple bucks more than you thought, but still WAY cheaper than Motion Pro.
And for someone such as myself that would only use it 1-2 times a year, would be the better choice.
http://www.harborfreight.com/blind-hole-bearing-puller-95987.html
Pmcg:
--- Quote from: alward25 on February 08, 2014, 03:27:49 AM ---Harbor Freight has one just like it, probably made in the same place for way cheaper. Like $50 or less and we know who has one the get the lower clutch bearing :-D right PMCG :wink:
--- End quote ---
Absolutely. I'm waiting for the appropriate amount of time to pass so I can borrow it again. I "may" have driven the new bearing in a little to aggressively. Ill know for sure once I get it running.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version