Author Topic: Oil Dripping (THICK) from muffler exhaust connection  (Read 24312 times)

0 Members and 1 Guest are viewing this topic.

Offline sandblaster

  • Administrator
  • Hero Member
  • *****
  • Posts: 8,275
    • OEM-CYCLE QUALITY USED PARTS
Re: Oil Dripping (THICK) from muffler exhaust connection
« Reply #15 on: July 29, 2013, 07:59:43 AM »
Fixed your pics  :-)
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline Shredstar

  • Jr. Member
  • **
  • Posts: 17
Re: Oil Dripping (THICK) from muffler exhaust connection
« Reply #16 on: July 29, 2013, 08:25:07 AM »
Thx I didn't know which link to copy

Offline The Flyin Hawaiian

  • Hero Member
  • *****
  • Posts: 597
Re: Oil Dripping (THICK) from muffler exhaust connection
« Reply #17 on: July 29, 2013, 09:42:37 AM »
I had several 03 and 04 KX250s that acted the same as yours and all of them turned out to be a crank seal. At first we tryed to rejet without any improvement. I went through several race seasons trying to find the issue. Spoke to factory reps and changed 2stoke oils brands. It ended up being an ethanol problem. Some may not believe that that was the problem but I switched to straight 110 Cam 2 race fuel and all my crank seal problems ended. Ive been using it for over 2 years now without any seal failures. At first we were using 1 gallon of race to 4 pump and I was replacing seals twice a year on 2 bikes. We switched to a 50/50 mix and our seals lasted almost the whole season. We finally switched to 100% race and the seals are still in there after over 2 seasons.
Symptoms with our bikes.
Bogging/breaking up at high RPMs Smoking like crazy!
Thick black oil dripping out of the silencer
High trans oil consumption at the faster races, higher rpms. Didnt notice it as much at the tighter, more technical races where the rpms are low.
The clutch side seal would come out rock hard everytime.
Try rejetting, if that doesnt help I would look toward the crank seal. The bike is 9 years old. Unfortunately you have to split the cases to replace them. Cometic sells a viton rubber crank seal set that resists the effects of the ethanol allowing you to run the crappy pump fuel.
A couple of 03 and 04 KXs, a few YZs, 3 PE 400s, a DR and a TS.

Offline TJXK

  • Full Member
  • ***
  • Posts: 153
Re: Oil Dripping (THICK) from muffler exhaust connection
« Reply #18 on: July 29, 2013, 05:59:18 PM »
I only put 92 octane non-ethanol gas through my kx250 since my dad's lawnmower had all of its seals go bad from standard pump.  Everything seems to work great, but it's $4.95 a gallon.

Offline Charlie500

  • Sr. Member
  • ****
  • Posts: 303
Re: Oil Dripping (THICK) from muffler exhaust connection
« Reply #19 on: July 30, 2013, 12:52:49 AM »
I only put 92 octane non-ethanol gas through my kx250 since my dad's lawnmower had all of its seals go bad from standard pump.  Everything seems to work great, but it's $4.95 a gallon.

Thats the same stuff i'm running in mine
2014 KX 450 Bark-Buster

Offline sandblaster

  • Administrator
  • Hero Member
  • *****
  • Posts: 8,275
    • OEM-CYCLE QUALITY USED PARTS
Re: Oil Dripping (THICK) from muffler exhaust connection
« Reply #20 on: July 30, 2013, 03:56:21 AM »
Yep, that's what I run in all my wiz bang machines.
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline Shredstar

  • Jr. Member
  • **
  • Posts: 17
Re: Oil Dripping (THICK) from muffler exhaust connection
« Reply #21 on: July 30, 2013, 04:03:13 AM »
So now I've got my carb off can you guys tell me the first steps as to what to check and engine to clean it please, I've bought some carb cleaner, any tips I need to know about? And what things to I need to know of? And how do I seperate the main needle from the large silver jacket thing?

Offline The Flyin Hawaiian

  • Hero Member
  • *****
  • Posts: 597
Re: Oil Dripping (THICK) from muffler exhaust connection
« Reply #22 on: July 30, 2013, 09:20:55 AM »
Unfortunately for me non ethanol fuel isnt available near me. The pilot jet in my DRZ400S cloggs up if it sits for more than a month with our pump fuel.
A couple of 03 and 04 KXs, a few YZs, 3 PE 400s, a DR and a TS.

Offline sandblaster

  • Administrator
  • Hero Member
  • *****
  • Posts: 8,275
    • OEM-CYCLE QUALITY USED PARTS
Re: Oil Dripping (THICK) from muffler exhaust connection
« Reply #23 on: July 30, 2013, 10:34:04 AM »
Unfortunately for me non ethanol fuel isnt available near me. The pilot jet in my DRZ400S cloggs up if it sits for more than a month with our pump fuel.

No boat dock around there?
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline TJXK

  • Full Member
  • ***
  • Posts: 153
Re: Oil Dripping (THICK) from muffler exhaust connection
« Reply #24 on: July 30, 2013, 02:15:00 PM »
I used google to find the place nearest to me.  Turns out it was five blocks away.  :roll:

I was new to the area.

Offline turdle

  • Full Member
  • ***
  • Posts: 104
Re: Oil Dripping (THICK) from muffler exhaust connection
« Reply #25 on: July 31, 2013, 12:58:48 AM »
go to puregas.org. click on your state and go fill up!!!

Offline Shredstar

  • Jr. Member
  • **
  • Posts: 17
Re: Oil Dripping (THICK) from muffler exhaust connection
« Reply #26 on: July 31, 2013, 04:31:52 AM »
guys ive found a brill link of a guy who shows how to strip clean and jet http://www.youtube.com/watch?v=jRBA1gHlx6k&hd=1

il use my laptop and have the vid at the side of me as i work, do you guys know which i way i should alter my jets? should i make me needle jet 1 main jet 1 grove richer any advice at this point woud be highly crucial, as my carb is off and my bikes in bits ;D

where i ride is 950ft above sea level.


Offline The Flyin Hawaiian

  • Hero Member
  • *****
  • Posts: 597
Re: Oil Dripping (THICK) from muffler exhaust connection
« Reply #27 on: July 31, 2013, 10:52:39 AM »
I have a friend who has a store at a marina near me and there is no ethanol free gas there. Been to puregas and there is one station about an hour away but I believe its regular. Im a road mechanic for a forklift co. and drive all over nj, pa and de. and its all 10% ethanol.
A couple of 03 and 04 KXs, a few YZs, 3 PE 400s, a DR and a TS.

Offline TJXK

  • Full Member
  • ***
  • Posts: 153
Re: Oil Dripping (THICK) from muffler exhaust connection
« Reply #28 on: July 31, 2013, 03:02:27 PM »
That's crazy.  It's pretty readily available here in Oregon.

Offline supergenius

  • Newbie
  • *
  • Posts: 7
Re: Oil Dripping (THICK) from muffler exhaust connection
« Reply #29 on: August 06, 2013, 07:21:00 AM »
Go t0 32:1 and ride it on the pipe. Mine yused to have alittle spooge, jetted appropriately at 32:1 (927) went to 40:1 and it started, and I ride it on the pipe a lot. Went back to 32:1 and it stopped. Its the fuel, not the oil... Seems counterintuitive, but its true.... ASSUMING its jetted correctly and as mentioned the Silencer and air filter are good to go  :)