Maintenance & Technical > KX500 Original
2000 KX500 Project
Pmcg:
And now for the manliest thing you can do with a kx500 crank bearing.
http://s129.photobucket.com/user/patmcgurrin/media/IMG_1313_zps15a257b4.mp4.html
sandblaster:
Nice :-D
Pmcg:
I got the trans back together. All new snap rings. It helps having another trans for reference
Pmcg:
I got the linkage rebuilt. I purchased an all balls kit and it was crap needles falling out all over the place. I sent it back and went with the pivot works set and was much happier
I'm having a hard time with the right side swing arm needle bearings. I've wrecked 2 already using both the draw bolt and a vise. The inside is clean but just seems too tight. I've heated and frozen each time. I think I'm going to have to take a bit of metal out with the deemel. Any advice?
Pmcg:
Got my head back from Larry. A++++++++++++ workmanship
He even fixed my stripped out drain plug
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version