Maintenance & Technical > KX500 Original
13T Front Sprocket
USMC 500:
Team Green used to run 16/42 gears down in baja.....unless I'm missunderstanding this thread a 13t should fit with room to spare.
Millertime:
--- Quote from: USMC 500 on April 01, 2012, 10:08:32 AM ---Team Green used to run 16/42 gears down in baja.....unless I'm missunderstanding this thread a 13t should fit with room to spare.
--- End quote ---
This has me puzzled as well that a 13 tooth front sprocket doesnt fit as it will rub on the case yet it was suggested to run a bigger 14 tooth sprocket? :?
Polar-Bus:
--- Quote from: Millertime on April 01, 2012, 11:21:13 AM ---
--- Quote from: USMC 500 on April 01, 2012, 10:08:32 AM ---Team Green used to run 16/42 gears down in baja.....unless I'm missunderstanding this thread a 13t should fit with room to spare.
--- End quote ---
This has me puzzled as well that a 13 tooth front sprocket doesnt fit as it will rub on the case yet it was suggested to run a bigger 14 tooth sprocket? :?
--- End quote ---
You guys are assuming the OD of the chain rubs the case, this is not the issue. The 13T sprocket chain id , will grind the id of the diameter around the boss for the trans output shaft.
Twosmokerfan:
Ahhh, I see said the blind man..... :-o
USMC 500:
I knew that.....I was just testing you guys thats all..... :-D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version