General > In General...
Post Pictures of your KX!
motopunk:
--- Quote from: Oblivious Maximus on August 10, 2014, 12:51:16 PM ---Thank you sir, sometimes things done in desperation work out well in the end.
--- End quote ---
yes..full agreed .. i thought of doing the same with the rad-plastics, but was not sure, if it will fit correctly to the tank...
Foxx4Beaver:
it's a pretty common thing to see here in the states, even on the 500's.
Oblivious Maximus:
The holes line up but it's not a perfect fit. The fronts tip upward leaving a gap between the shroud and the recess in the tank of about 10 -11mm at the lower rear corner. The space it reveals is a little dull from the original plastic which draws attention. I guess a little polishing would help.
motopunk:
--- Quote from: Oblivious Maximus on August 11, 2014, 11:21:38 AM ---The holes line up but it's not a perfect fit. The fronts tip upward leaving a gap between the shroud and the recess in the tank of about 10 -11mm at the lower rear corner. The space it reveals is a little dull from the original plastic which draws attention. I guess a little polishing would help.
--- End quote ---
if the holes line up perfectly, is the rest easy going with little bit handcrafting... :-)
Oblivious Maximus:
In my case everything bolted up fine with no more fitting and is good enough in my camp.
You can see the mismatch at the tank in these pictures.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version