Maintenance & Technical > KX250 / KX125

kx250 wiring diagram

<< < (2/2)

Magnus:
Thanks a lot :-) I owe you one!

don46:

--- Quote from: Magnus on May 29, 2011, 10:45:16 PM ---If you are working on a 2003 kx250, can you check something for me?
I need to know if the timing marks on the stator and flywheel align when the piston is at tdc.. I know the timing advance is 14? BTDC at around 7500 rpm, but I don't know if the timing marks are supposed to align at tdc 14?, tdc or something else... Reason I am asking is I am thinking of using the 250 ignition on my 500. I still have to check the timing with a degree wheel and strobe light, but would be nice to know roughly were to start :roll:
Any input would be appreciated 

--- End quote ---

The marks on the flywheel and the stator line up at 14 degrees not TDC.

Magnus:
Thanks Don. Its just the answer I was looking for

royceymon@hotmail.co.uk:
i thought you might get the answer before i looked with the welth of information of the kxriders site!!!

Navigation

[0] Message Index

[*] Previous page