Maintenance & Technical > KX100 / KX85 / KX80 / KX65 / KX60
KX60 HELP! In need of rebuild!
Motorrad:
Always replace the seals if you have it appart...
They are cheap... and its NOT CHEAP if they fail... (motor go boom)
chris-mets:
Ok thanks for the advice. I just sold a bike I found in the garbage to some guy in Pennsylvania for $80! haha I will look for some type of bond for it and try to get the bearing and seal out. My friend has mr.gasket I think he said would that work? and Im borrowing his torque wrench too. The motor is at my friend's house right now cause we had to use the air compressor. The engine is split and the old shaft is off. There was a lottt of gunk stuff on the bottom where the shaft is and it looked like dirt but it wasnt. Im gonna clean the whole thing up. Thanks.
chris-mets:
and also how much yamabond do I buy?
Motorrad:
--- Quote from: chris-mets on May 04, 2011, 10:02:51 AM ---and also how much yamabond do I buy?
--- End quote ---
1 tube is enough for many motors...
Mr Gasket is a gasket dressing... ment to put on automotive gaskets before assembly.... not the same thing as what yamabond ETC. does.. as they are a Case sealant..
chris-mets:
Ok thanks but how much yamabond? 3 oz? theres different sizes.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version