Maintenance & Technical > KX100 / KX85 / KX80 / KX65 / KX60
KX60 HELP! In need of rebuild!
crazyolbastard:
--- Quote from: chris-mets on August 20, 2011, 03:22:14 PM ---Yeah I have a propane torch but wouldnt heating it up extend the metal? Thanks for the help
Chris
--- End quote ---
It would expand, but if the heat gets to the inner piece,
it will push on the outer making it larger.
then let them cool- they may come apart then.
don`t get them red hot, just heat them up a little.
good luck,
I am guessing the peddle is aluminium and the "post" is steel.
the steel needs more heat for the same reaction.
if you can GENTLY warm just the peddle it may pop apart.
Again, I`m guessing on what the materials are
crazyolbastard:
I read somewhere not to heat alum. more than one time
1989kawasaki:
id say if its extremely difficult to remove it just cut it off and get a cheap used one on ebay.
but try to get this one off first
chris-mets:
Ill try again tomorrow..
chris-mets:
Hey guys,
I put all the decals on the yz except for a few that looked really bad on it like the front fender curve that says the website name...and there were 2 others of the same that I cant find where they go...I have to go to a doctors well visit since it was just my birthday so when I get back I will try to repair the rear brake...Thanks
CHris
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version