Maintenance & Technical > KX100 / KX85 / KX80 / KX65 / KX60
KX60 HELP! In need of rebuild!
1989kawasaki:
--- Quote from: chris-mets on April 09, 2011, 09:37:33 AM ---I found a connecting rod with bearings for 65 then he said he could put it on for 30 more bucks.
--- End quote ---
who said he could put it on for $30
chris-mets:
the listing on ebay. but nevermind. I am going to open the engine then take the crankshaft out and take the old rod out and put the new bearing and rod in. It's held in by a pin just like the piston so it's not hard.
1989kawasaki:
--- Quote from: chris-mets on April 13, 2011, 12:26:19 PM ---the listing on ebay. but nevermind. I am going to open the engine then take the crankshaft out and take the old rod out and put the new bearing and rod in. It's held in by a pin just like the piston so it's not hard.
--- End quote ---
its not like a piston pin, your going to need a big press to do it , but it is not practical . you need to take it to a shop
chris-mets:
i unscrew the two allen holes on the bottom of the connecting rod then replace the bearing and rod
1989kawasaki:
--- Quote from: chris-mets on April 13, 2011, 12:36:29 PM ---i unscrew the two allen holes on the bottom of the connecting rod then replace the bearing and rod
--- End quote ---
what allen holes?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version