Maintenance & Technical > KX100 / KX85 / KX80 / KX65 / KX60
KX60 HELP! In need of rebuild!
Motorrad:
--- Quote from: chris-mets on May 04, 2011, 10:13:09 AM ---Ok thanks but how much yamabond? 3 oz? theres different sizes.
--- End quote ---
3oz tube is the only size any motorcycle shop I have delt with has..
mdw471:
--- Quote from: Motorrad on May 03, 2011, 03:44:10 PM ---
--- Quote from: chris-mets on May 03, 2011, 01:47:10 PM ---Thank you very much! just an update everyone that the cases are split and the old crankshaft is out. I do not know if I should replace the bearing and seal that is in the case to the right side. It looks good but I don't know. Also do I have to seal the cases with silicon again when I reseal the cases? Thanks.
--- End quote ---
Silicone=Bad.
Yamabond 4=good (honda Bond, Three bond 1194, etc etc)
--- End quote ---
YAMABOND 4 is sorta like fat bottom girls......
delphipro5:
What about HYLOMAR? Not the same as yamabond?
Motorrad:
--- Quote from: delphipro5 on May 07, 2011, 04:05:35 PM ---What about HYLOMAR? Not the same as yamabond?
--- End quote ---
I use halomar for intake gaskets..
But it will NOT WORK as case sealer..
delphipro5:
Thanks, good to know.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version