Maintenance & Technical > KX250 / KX125

Not so hot

<< < (3/3)

myckmcclung:
I have used Hotrod rods in my last two  bottom end rebuilds with no issues. I pour straight 2stroke oil on the main and small end bearings during assembly
what oil gas ratio do you run??
How many hours were on the bottom end?
Was the main bearing lubed during assembly?
Was it installed by a qualified mechanic??
all of these are ?? you need to consider before bashing. if the rod is straight then what's the problem, bearings wear, and it could be that your crank bearings weren't replace when the crank was rebuilt.

Navigation

[0] Message Index

[*] Previous page