Maintenance & Technical > KX500 Steel Frame Conversion (SFC)

GEARBOX CASE SWINGING ARM MACHINING KX500 INTO KX250 2003 SF

<< < (2/2)

BDI:
43/64 if the bit I use. It works great. I recomend drilling the cases as a unit or you may not get the pivot bolt threw to to the tight tolerances.

sandblaster:
Ditto.
I drilled them together with the clutch side resting on some parallels.
It made a nice perpendicular hole through both cases.

VON DEM:
THANKS FOR REPLIES , JUST I LITTLE WORRIED ABOUT MACHINING ARM TO MUCH , HAS ANYONE HAD PROBLEMS WITH BREAKAGES , THANK YOU

Navigation

[0] Message Index

[*] Previous page