Commercially available service offered by members of KXRiders. > Powerdynamo Ignition w/ 100 watts of lighting

Crazy Al Racing's Powerdynamo Ignition/Lighting System.

<< < (25/28) > >>

alward25:
Great News!!!  We will all be waiting!

1901306708:
what is the farthest advanced you've run it, or heard of anyone going?

also, the measurements you give, are you talking vertical or in the same plane as the plug hole. ie if you had a dial gauge threaded into the sparkplug hole, its not travelling vertical but at the same angle the plug sits.

i don't have one of those fancy setups so i'm just using the end of a caliper held vertical in the plug hole

alward25:
Spend the $40 on ebay to get the good one, it will be more consistent,  The first time I did not have one and used calipers and held it square on the the hole, it took longer to get right than if I had just bought the right tool.

http://www.ebay.com/itm/PVL-ENGINE-IGNITION-TIMING-TDC-DIAL-INDICATOR-POLARIS-14mm-SPARK-PLUG-THREAD-/161755672671?hash=item25a963b05f&vxp=mtr

1901306708:
not going to get it by tomorrow am unfortunately. after that, back to work and done playing.

any insight as to how far anyone has run advanced, or if you're talking vertical or the same plane as the plug hole?

sandblaster:

--- Quote from: alward25 on July 17, 2015, 04:18:24 PM ---Spend the $40 on ebay to get the good one, it will be more consistent,  The first time I did not have one and used calipers and held it square on the the hole, it took longer to get right than if I had just bought the right tool.

http://www.ebay.com/itm/PVL-ENGINE-IGNITION-TIMING-TDC-DIAL-INDICATOR-POLARIS-14mm-SPARK-PLUG-THREAD-/161755672671?hash=item25a963b05f&vxp=mtr

--- End quote ---

I bought one... Last time I made my own.
It worked fine but this is too sweet to pass up  8-)

Navigation

[0] Message Index

[#] Next page

[*] Previous page