Maintenance & Technical > KX500 Steel Frame Conversion (SFC)
kx500sf project
DaveEngineering:
Looking good Jon, cant wait to see it finished.
jbersano:
great project.... great description!
jonny500:
the cr 500 pipe a got off ebay turned out to be a 250 pipe so the build has been held up
jonny500:
removed head stay, i will sand blast to give a factory finish (another of torches ideas)
jonny500:
after the ebay problem i purchased a new dep pipe. i had a sleeve adaptor made to join the pipe to the exhaust port, i will have to see how this works/seals. the bottom mount is a kx 500 damper mount with the hole elongated and the rear is one i made, i will make a proper one with a rubber later. i had to put 2 dents in it 1 for the water pipe and 1 to clear the top of the engine. if this works the only mods for changing the pipe will be the 2 dents so a stock cr pipe can be fitted in about 20 mins use a hammer. here some pics
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version