Maintenance & Technical > KX500 Steel Frame Conversion (SFC)
kx500sf project
Motorrad:
--- Quote from: DoldGuy on February 23, 2011, 09:10:13 AM ---Yeap! Pull the pins and swap ends & reinsert. IMO the pins are cheap enough to just replace & I bought a new center valve & will fight with the old one later.
--- End quote ---
I had to buy another center valve also... as whomever tryed to do the pin flip on mine, while the motor was not in my custody... beat the living crap out of my flapper.... to the point of it not being usable IMO...
jonny500:
hi don, the doordie pin flip (what i call it) all is described at 3.3 here http://www.hallbergs.net/kx500/
the pin flip went ok for me about the only thing that has lol
kaw rider:
I flip a set of pin on a cylinder and they loosen up and jammed up the powervalves and it stuck the powervalves and it was a pain to get out. So i tack weld the pins now.
jonny500:
motorrad, my ring gap is 14 thou. so thats good right?
Motorrad:
--- Quote from: jonny500 on February 24, 2011, 05:57:43 AM ---motorrad, my ring gap is 14 thou. so thats good right?
--- End quote ---
Perfect.. Your golden....
I just ordered 4 sets of rings in hopes one set will measure what yours do...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version