Maintenance & Technical > KX500 Steel Frame Conversion (SFC)
kx500sf project
DaveEngineering:
d**n that frame looks good now, and to think Tib didn't like the welds.
Cant wait to see it come together now. Rock on!! :mrgreen:
Danger4u2:
Good work, has a factory look.
sandblaster:
I'm really impressed.
I never read any of the SF posts till now.
Nice job.
jonny500:
with christmas out of the way, it time to get on with this and get it done, i sand blasted the swing arm and used wire/steel wool to get a brushed stock look.
jonny500:
i quick up date. crank is is going away tomorrow to have the journals welded and re-ground, wiseco piston is going with it to have the piston port put in. the crank will be rebuilt with an oem rod. it will all be dynamically balanced as a complete unit with the piston and oem gudeon pin (lighter that wiseco) and ignition flywheel. so it should, hopfully be a super smooth motor when built. awaiting bottom link and head stock bearings
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version