Maintenance & Technical > KX500 Steel Frame Conversion (SFC)
kx500sf project
jonny500:
Got another frame from ebay today its a 99, the frame i have is a 2000. all parts should transfer i hope? While i was on ebay a got a set of friction plates made by prox has anyone use these before? Here take a look
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=130427782636&ssPageName=STRK:MEWNX:IT
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=230525870312&ssPageName=STRK:MEWNX:IT
jonny500:
new frame has arrived. not great but will do with a bit of fettling. have striped the motor to find the con rod is bent. i also found that the flywheel had sliped. this could be the cause of the bent con rod, if the ignition had advanced. any veiws on this are welcome? the taper on the end of the crank is in poor condition now, any ideas on a repair for this? failing that i will renew the crank and flywheel. dose anyone have 1? even with a shot big end as i will renew the conrod anyway. here some pics
jonny500:
pic 2
jonny500:
more pics
ShadeTreeFab:
looks like some one went nuts with rtv. :-o
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version