Maintenance & Technical > KX250 / KX125

My 88/91 KX250 project

<< < (7/9) > >>

Caddy 16v:
A couple updates, got a front number plate, the proper rear shock (race tech revalve) and some Cycra handguards, also had my forks rebuilt.

Motorrad:
Are the bars as bent as they look in that last picture?? 

Caddy 16v:
The left side is bent, I was already considering to replace it, think I'll get a new one without the middle strut. Maybe a pro taper or something like that as long as it's not too expensive.

Motorrad:

--- Quote from: Caddy 16v on June 02, 2011, 06:42:39 AM ---The left side is bent, I was already considering to replace it, think I'll get a new one without the middle strut. Maybe a pro taper or something like that as long as it's not too expensive.

--- End quote ---

I have straightened bars worse than that...   Large hammer. and a buddy to hold the front wheel   :-D


Dont forget most protapers are bigger diameter on the mount.. so youll be buying those as well..

snoopjonnyjon:
If you're on a tight budget, most shops have steel bars for $20-30. If you don't crash much, there's nothing wrong with them.

Navigation

[0] Message Index

[#] Next page

[*] Previous page