Maintenance & Technical > KX500 Steel Frame Conversion (SFC)
04-06 RM 250 w/KX500 motor
kritter811:
Has anyone ever done one. Does anyone know what it might take?
Friar-Tuck:
Hey Kritter,
I don't recall seeing one, but a little patience, a good welder and a few pints of ale are usually a good start! :-D
Are you able to take some rough measurements of the Zuki & Kx engine ? Maybe if you could take some good photo's and measurements the guys could give you some advice. There are some great fabricators here, and several have taken pics of their builds.
Tuck\o/
ZETTNORCAL:
Dooable! now Do it!
it would'nt take any more work than the rest of these conversions.
BDI:
I have been thinking this would be very cool to do. I think it would be cool to have a yellow KX500 and have graphics made for and all that state it's a kx500. Sort of a yellow factory looking aluminum framed kx500 is what I have been picturing.
ZETTNORCAL:
I'm not sure, but I thought that the 04-06 rm250 was a steel frame.
Navigation
[0] Message Index
[#] Next page
Go to full version