General > Introductions

Hello. How about that ride in! i guess thats why they call this sin city haha.

<< < (2/2)

Goat:
Everything in moderation. You don't need to get the bearings red hot. Just warm to the touch should loosen them up enough to remove the bolt. Will still need to use the persuader (hammer) but it should come out. Since the bolt wont come out it's obvious you need new swing arm bearings so I wouldn't worry about the seals as those come in the bearing kit. Just make sure the carb is removed and there are no rubber lines in the range of the heat. As a precaution I would remove the gas tank if you haven't already. Hope this works for you.

Hman636:
Thanks. I have the bike completely torn apart. only thing left on it is Wheels and the motor.. I want to get the frame painted and The kick start gear does not catch all the time only when you push down and out on it. i saw some one else did a little grinding on the gear and fixed it them self. thanks for the tips.

kwakman:
goat's right.you dont have to go bezrek with the blow torch,just warm the offending area with it and some more swearing.good luck.

Hman636:
Hey thanks for all the help everyone. I got the swing arm shaft out. 1 Can of PB Blaster. A few good punches and a BFH, It took about 1 hour after 2 days of spaying in oil but it came out. When i went in the garage this morning she left me a surpirse on the floor. i have a oil leak from the sproket seal shaft? i think its a O Ring. i shouldnt have to take the case off right just be able to pull everything off of the shaft? anyways thanks for the help once i can put pics of ill show what we have been doing and my 00 kx 250.  8-)

Navigation

[0] Message Index

[*] Previous page