Maintenance & Technical > KX250 / KX125

Tips please

(1/4) > >>

kx250.1698:
Hi guys i have received my sprocket shaft  and was wondering should I install it myself.i am good with bikes and with my hands just haven't striped a motor before.Is there a trick or something i should know when i strip the motor or what?

Thanks

BDI:
The best trick you can use is a manual and the right tools. :-D

kx250.1698:

--- Quote from: BDI on August 02, 2009, 06:17:15 AM ---The best trick you can use is a manual and the right tools. :-D

--- End quote ---

What if you don't have a manual and the right tool?

dangerous dean:
you will def. need at least a diagram to show you which way the gears go on the shaft as well as where the shims are,as for tools if you can take it apart ok then it should go back together ok without the need for special tools etc.

BDI:

--- Quote from: dangerous dean on August 02, 2009, 12:07:17 PM ---you will def. need at least a diagram to show you which way the gears go on the shaft as well as where the shims are,as for tools if you can take it apart ok then it should go back together ok without the need for special tools etc.

--- End quote ---

 Just a diagram and no special tools needed :? well hell it should ba a snap then.

Navigation

[0] Message Index

[#] Next page