Maintenance & Technical > KX250 / KX125

Crank seal

<< < (2/2)

KXcam22:
Is there any reason why that seal can't be removed from the outside, similar to a shiftshaft seal? Looks possible, what am I missing. Cam.

cbxracer30:
If that is a crank shaft seal it looks as if the last person put it in backwards or upside down depending on how you look at it. and there should be a lip on the inside of the case that would keep you from pulling it out from the outside.CBX

kaw rider:
A seal puller should get that out.

BDI:
What is thast thing an 85 :? If you can dig it out you have to be super carefule or you will scratch the machined surface that the seal presses into and the new seal won't seal in the case.

KXcam22:
No lip shown in the photo.  I am not familiar with that particular bike but most times I have put the seal in from the outside after the bearing is installed.  Cam.

Navigation

[0] Message Index

[*] Previous page