Maintenance & Technical > KX250 / KX125

Update on my '89 KX250

(1/3) > >>

keithluneau:
Just wanted to post an update. Today I installed new front a rear fenders, grips, and a clutch lever. I've also got a gripper seat cover to put on, just haven't tackled that yet. I did cut the seat pan to fit the rear fender already though. I think it looks MUCH better already, and should look even better once I get the graphics for the shrouds and tank, and get the cover on the seat.

DoldGuy:
Looks Good!! Keep at it  :-D

keithluneau:
Thanks! I just came back in from putting the seat back on. I took it in the house and put the cover on earlier. (Mosquitoes are too bad in Louisiana to be outside too long at night! lol)

It came out better than I expected. I actually got the cover on straight with no wrinkles! Until I put it on the bike that is... ;) The tank pushes the front of the seat back, and the cover loosens right in the bend. Oh well, maybe it'll tighten up if it shrinks at all. If not I can live with it. Picture tomorrow when the sun is up!

kx250.1698:
dam prity kwl man good luck, now you must just spary the bike.

keithluneau:
Pictured with the seat cover on... You can see the wrinkles at the front in the bottom of the bend, I can live it that though it it doesn't tighten up on it's on once it's worked in...  :wink:

Navigation

[0] Message Index

[#] Next page