Maintenance & Technical > KX500 Super Motard

kx450f supermoto rims on a 95 kx500

<< < (2/4) > >>

muleman:
Both very good Idea's. So i mite just get them any way and make them fit.

muleman:
Rims will be here fri.  :-D

Motorrad:
 

Sweet please document everything you have to do to get them to fit as I will be doing the same most likley..   

muleman:
Ok I have the rims and going to do mic the bearings and order a new set with a 20mm center.

muleman:
Of corse to get the same bearings as the dna wheels with the 20mm center bore is impossable. Well for 350.00 each I can get them from a aveation place  :-o
 I am going to run 1 6204 20x47x14mm on the brake side. It is only 2mm wider and I think I can get the seal to fit with very little work. The other side I am going to try a 20x47x20.6 in place of the (2) 12mm wide bearings and then make a small spacer 47mmX 3.4mm to take of the diffrents in the 2 12mm (24mm).  I post pic when I get all the bearing

Navigation

[0] Message Index

[#] Next page

[*] Previous page