Maintenance & Technical > KX250 / KX125

Can some one with a workshop manual help me please

<< < (2/2)

KX500freak:
from the inside oil passes by the seal ,it should atleast .
but the outside is better off clean and dry.
but if it,s fitment goes better with,use some acid free grease ,
and clean thoroughly the surface off the seal outside

Adon:
Its now in. Just hope that is what was making it leak!

KX500freak:
must be good now ,did you use grease or not  :wink:

Adon:
I just used it dry ey. Went in fine. Just a little o-ring. The old one wasn't the easiest to get out though :lol:

KX500freak:
you managed to get it out with the screws ,
or did you yanked a driver tru and tore it off :lol:

Navigation

[0] Message Index

[*] Previous page