Maintenance & Technical > KX500 Aluminum Frame Conversion (AFC)
KXF /KX250
Dutch-K5 Fan:
25x25mm and 2mm thick is stock!!!! Should be good than.
Tomorrow I'll start working again, so I can go further with it.
And give some pics and info again.
Dutch
Reddy:
Just wondering if you guys bend the ali tube?
Just I need to connect the Y piece down to the original frame and thee is a bend at the end.
Any ideas would be good.
Dutch-K5 Fan:
I'm planning to make mine own bender. With this as an example.
http://mittlerbros.com/tube_bender_180_hand.htm
And buy 6 metre alu tube to try :-D
Whow is gone weld your bike??
dutchie
Reddy:
Thats like th tool i was gonna try and build!
But i dont know how well it will work.
Got a local Ali welder that races local to me, so he's gonna do it all :)
Dutch-K5 Fan:
Welllllllllllllll.................To be honest I didn't found that link, is't JFAB's :oops:
But hat more or less the same idea, only wasn't sure if it could work.
I think to go to a old famely friend(JBR SERVICE) for the welds.
When you see al of those 500's over here. Don't you whant it also than???
Or is that the next step??? :-D :-D
dutch
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version