Maintenance & Technical > KX250 / KX125

bottom end/bearings

<< < (2/3) > >>

Jeeks:
OK, the THREADS are stripped or where the Phillips screwdriver goes is stripped?  I hope you didn't use an electric drill to get those screws out. :-o

 

don46:
What is the white crap that looks like grease in the first picture?
As ugly as it looks, I would replace all the bearings and seals.
I have had to use a small chiesel on the head of the screw after they'd been rounded, tapping it on one side, then of course replacing the screws.
Motion Pro makes a blind bearing puller, it's kinda spendy, but if your going to do more in the future it's well worth the money.

http://www.motionpro.com/motorcycle/tools/blind_bearing_and_bushing_remover/

Kawasakinut:
don that is just some white lithium grease. yeah these screws are screwed. f  meeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee!!!

don46:
how did the grease get in there?

Try the chiesel trick, they'll come out, just be paitent

Kawasakinut:
              jeeks i would never think of using an electric drill to remove those screws :wink: :wink:.   

don that trick was tight. worked real good. i sprayed the grease in the case bearings to see if they would spin free. they where all gritty and notchy so i have decided to change them all.

         

Navigation

[0] Message Index

[#] Next page

[*] Previous page