Maintenance & Technical > KX250 / KX125
clylinder question
Jeeks:
Bring it to a local macine shop or engine builder to have it measured.
Kawasakinut:
what are your thoughts on (l.a. sleeve) are they a good or bad company? are there others that you guys use, or know of. i am thinking of sending this cylinder out to complete the top end. l.a. sleeves website says that they will relieve, champher the ports, hone and fit with piston and rings and supply the lube for completing the top end. I'm not sure what their price is. any suggestions?
jimmy v.
BDI:
la sleeve is a good company from my experience
stewart:
plated
Jeeks:
Did you have the cylinder measured? If it comes within specs, you're wasting money on a sleeve. You're going to have the most expensive 2000 KX250 to roll out of PA soon.
-just sayin'
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version