Maintenance & Technical > KX250 / KX125

clylinder question

(1/4) > >>

Kawasakinut:
got my clylinder here and not sure what to do found a good sized mark that can be felt by hand. in the manual it says to replace the cylinder if worn since the electrofusion cylinder cannot be bored or honed!! so this cylinder is plated then? if so it can be replated right?

stewart:
that cylinder looks sleeved

Kawasakinut:
stewart thats why i'm confused it says electroplated in the manual, but i used a magnet and it stuck pretty good so that would indicate
that it is sleeved?

stewart:
yes it looks like it to me  what does the bore mesure

Kawasakinut:
not sure i haven't bought a dail bore gauge or mic set yet. my birthdays on the 19th if ya'll want to buy me some presents.

Navigation

[0] Message Index

[#] Next page